Steps
Measure the size of the panel or component you want to wrap. Use cutting tool or a clean sharp blade
Wash down the surface of the area you want to wrap with shampoo and water, making sure that any dirt and grime is completely removed. Avoid using wax or specialist car shampoo that contains wax, as this will affect the films adhesive.
Remove the backing paper from the wrapping film, being careful not to be touch the adhesive or get it dusty or dirty. Side the film into position the adhesive wont stick until you apply pressure, so now your chance to get it in exactly the right place.
Use the edge of Squeegee to apply firm pressure in wide, even strokes. Work from the centre, smoothing air outwards towards an exit at the edge of the film. Special channels within the adhesive backing will minimise the risk of bubbles.